Ford BTR 4 Speed Fully Programmable Transmission Controller

Description

A fully programmable transmission controller to suit the Ford BTR 4 speed transmissions
(Suitable for EB,ED,EF,EL,AU 4 Speed Transmissions – NOT Suitable for BA / BF 4 Speed Transmissions)

Shift points and downshift points for each gear can be mapped

– Line pressure for each gear can be mapped
– Full control over Torque converter lock and unlock parameters
– Optional RPM based shift mode to allow consistent shifting at the selected RPM per gear for 1/4 mile vehicles

– Switchable Automatic or Full Manual mode
– Optional inputs for upshift and downshift paddle switches
– Optional programmable speedo output

Requires electronic vehicle speed signal
Requires throttle position signal
Requires a square wave electronic engine RPM signal – can not be connected to coil negative!
– you will need a suitable ignition system with a dedicated tacho output wire, ie ICE, MSD, MALLORY ignition box

Requires factory transmission harness as this is a wire in controller, 1x round transmission plug and 1x 2 pin gear position switch connector

Supplied with a wire in harness, Installation Instructions, Software and Programming Cable

Please note that these controllers are aimed at the performance market and will NOT give smooth shifts like the factory controller, these controllers will give a sharp, firm shift even at low line pressure settings.

Additional information